Hi All
Recently we're upgrading exchange 2007 sp3 to Exchange 2013, but I encountered a wierd problem during the exchange 2013 install.
Everything was good during schema prep, adprep, domainprep.
During the installation, it had a problem with discoverysearch mailbox, i followed one of the article over the net, which is disabled it and then re-enabled, then successfully resumed installation. (It's 10/14 steps at that time, which is mailbox role)
BUT, few seconds later after resume, the installation window disappear, I am not sure whether it's running at backend or it's just stopped running, so i waited and waited for nearly 1:30 minutes. I checked all the services, it seems to be all started.
I try to run the setup from installation media again, the first window saying is "incomplete installation detected", then I click next, it's just stuck at 0% percent.
I restarted computer, after reboot it's still showing me incomplete installation detected, then click next, it will stay at 0%.
If i try to open ECP page, it throws me an error, same as OWA. For some reason, the ECP doesn't use port 443, instead it's using 444. Both error looks like there's some configurations missing. It looks like the client access role hasn't been installed successfully, as in my IIS, the default website only shows powershell under its virtual directory.
I am wondering if anyone has experienced any of the above problem, any solutions?
Thank you very much